Artificial Lawn Installation Guide

Equipment needed for your Artificial Lawn Installation: spade, turf cutter, hand roller or vibrating plate, wheel barrow, a sharp Stanley knife, large pair of sharp scissors, stiff brush, hammer, pegs, geo-textile, rake.

Ground Preparation for Artificial Grass

installation-drawing1

Remove all vegetation and rocks, down to the bare earth using a turf cutter or spade.

installation-drawing2

A sub base of sand is installed. This base should be porous.

Spread, level and compact the sub base with a hand roller or vibrating plate.

installation-drawing3

During dry conditions wet the sub base a day before the installation.

Peg a geo-textile weed barrier to the base.

In some certain circumstances you may need to use the wooden border.

Installation of Artificial Grass on Gardens

installation-drawing4

Cut carefully in the backing of the artificial grass and trim.

installation-drawing5

Fix with adhesive or stainless screws on wooden beams (treated to prevent moisture) or with stainless nails in the sub base.

installation-drawing6

Brush in sand (depending on grass product). Sweep dry kiln sand into the pile after laying the grass to weigh the grass down and stand the grass pile up.

 

Seaming Tape - Adhesive (if joining)

installation-drawing7

Adjacent rolls should be laid together ensuring that straight cut edges can be butted close together.

Butt both surfaces together, ensuring the pile is running in the same direction.

installation-drawing8

The seaming tape is used to put the rolls together. Unroll the seaming tape along the seam line, ensuring equal tape laid centrally along the seam.

installation-drawing9

Apply the adhesive with a spatula or glue cartridge gun to the top surface of the seaming tape.

 
Installation of Artificial Grass on Existing Hard Surfaces

installation-drawing10

Remove surface imperfections.

Thoroughly clean to remove all dirt, paint, grease that will prevent good adhesion.

installation-drawing11

Rolls can be loose laid or fixed with a spots of outdoor adhesive or with double-sided adhesive tape.

installation-drawing12

Brush the piles once installed.

Depending on grass product sweep dry kiln sand into the pile after laying the grass to weigh the grass down and stand the grass pile up.